Recent content by ACDS

and what? can share?

this is already a good duration, 60% longer than mine .. Tao Bao is an internal store only for the Chinese, buying there is carried out either through intermediaries or through other resources that are partners to taobao. You can do it yourself, but you need to register - and there are problems...

Google Chrome, right mouse button - translate ...

Shop (link to the store) - mods Chinese brothers suggested livehack how to make sure that the percentages and time on a double battery were shown correctly. You just need to solder to the current-measuring resistors are the same in the parallel (for example from above). The capacity will show...

Wonderful job! But..! I believe that it is necessary to connect not only the main contacts, but also the balancing contacts to the main board. Parallel.. Since the processor calculates the voltage and capacity on each battery bank and summarizes and gives the total capacity for the program - the...

The cells themselves can be composed and the controller should recognize them, but the point is in their sizes. You need to either look for cells by size or make a new package based on these sizes, but then you can increase the capacity of the cell to the desired power. For example similar 6...

I think, just like in your picture - it is impossible. It is necessary to bring the battery leads under the main battery board so that the battery software determines the total capacity + wiring of the battery cans. correct me if not right.

I have a similar problem - I can not answer anywhere. There is an alternative, but paid, while I think I need to buy or not ..- Pano Amigo ‎Pano Amigo for DJI Drones

It is not necessary to raise the height restriction for Inspire due to flight time limitations. I have firmware with the restrictions removed. For the sake of interest, I climbed to a height of 950 meters. But further I do not see the point in this. 500 m is a sufficient height for the work of...

The problem of the bent camera contacts is a consequence of the wrong installation of the cover. according to recommendations it should be placed on the marker on the right - this is a big error leading to spoilage of contacts. If you put the lid - put a marker back from the clamp marker, only...

Repair is possible. Spare parts are easy to find on ebay and in some stores. However, there is a problem in the subsequent recalibration. I repaired my X3 but I could not fully and correctly calibrate it. I was not lucky. Recalibration is possible only in DJI, but the price is not known. Forgive...

In the control application of the flight, the DJI GO defaults to the height and range limitation of these numbers, which you call. DJI GO into the application n-settings and change the maximum altitude and range and uncheck the checkbox.

To re-flash the old version or the same firmware version, additional files are required for the firmware. create an additional file WM610_FW_DEBUG without an extension with zero cost and put it together with the firmware and run the firmware process. The firmware will pass correctly. Important...

For a whole week I corresponded with the support DJI. They do not give their address support and repair and all the time trying to shift responsibility to regional dealers. In the last letter they decided to send me to the dealer in France. Horror! And they do not answer the price of repair at...

awful story, I'm sorry for your bird and the collapsed hope .... I tested many applications for the flight, specified in the survey. However, I dwelled on the application of DJI GS Pro. I also realized that there was no problem, you need to work with two software at once. It does not matter...