Recent content by Budster

I own an Inspire 2 which I have sent to Seattle Drone Repair located in 2 locations, One Seattle, the other Tacoma, Washington. They are reasonable priced, know what they are doing and have a good turn around with great communication. No complaints. I've used this service also for my Mavic's.

After trying several ways, even using a MAC and a calibration board, my Inspire will only reach 71% before failure. It never completes. Any help here would be great. It's not that it doesn't see the patterns, it's after it has completed the patterns and finishes, but never does.

Thank you, I will

Yes, and after further inspection I found the right arm is loose no matter how tight I tighten the guide ring. I understand a slight play could be there, but this had too much play. Din't think to check the non-obvious. So I've placed an order for the right side, should be back up by weeks...

Good Morning, yes, I just did that and the aircraft still has a wobble. I'm able to launch and hover but so so easy..raising landing gear gives a little better ride, but I have no errors coming up in the menu of issues to have, nothing indicates there is a problem, however there definitely is...

After replacing the left arm, I now have a wobble and can't discover what is causing it. The aircraft drifts and wobbles when I lift off about 1' in air. Acts like motor stablization or bad blades? What would cause this to happen? Thank you for your help.

Just so you understand, I purchased my Inspire 2 used, so the camera is as well, but good as new, works perfect.

So your looking for a X4S, I have one I got with the Inspire 2 but have upgraded to the X5S. I'm looking to get at least $300.