Recent content by creativedogmedia

This has been sold. Thanks!

Sorry. Located in Virginia and USD.

Selling my backup Inspire 2 with X5S camera (no lens). A small branch reached out and grabbed it back in July and broke a leg. Had it repaired it back to 100% and I simply don't have a need for it (I bought a new one a week after the tree did that to my drone as I had projects in motion)...

Yes.

Experienced something strange this morning. Granted, it was -1° at sunrise but as soon as I launched and landing gear raised, it was as if a motor wasn’t acting correctly and the aircraft would start wobbling. Drop the landing gear....perfect. In fact, I continued to fly and got through 6 sets...

I had a friend and long time member of the RC/UAS community replace a leg on my I2. I picked up another one while that was being done so if anyone is looking for a good deal on an I2 with an X5S, let me know. Thanks.

In my opinion, this is a firmware glitch that is fixable. I have heard virtually every reason in the book named as the cause for this and even had a DJI employee state "oh, this comes from flying when it's really hot outside." False. My iPad Mini 4 worked FLAWLESSLY even when the Inspire 2...

Anyway what? Just playing back what happened. I'm fully aware of how it's supposed to work. The fact is, it didn't. What do I know.....I'm extremely bored with nothing better to do than make up RTH stories.

Yep, that's right. 5 mins. A few times have been less but the longest one was 5 mins and it did start to RTH but it certainly wasn't after 3 seconds. After a couple of minutes, I killed the app and even rebooted the RC. Eventually, RTH kicked in and I took over.

I've been losing connection at ~2000ft. My previous 3 days of flying has seen this occurrence in each day (totally different environments). Not just poor/choppy connection but complete disconnect, in some cases up to 5 mins at a time. It's gotten way worse compared to when it was first released...

On my new props, the only ones that have the "2" on the underside are the white ones.

Got 2 new sets of props today with the foam fix in them. It fixed the rattle on both red sides but there apparently is a screw loose on the adaptor or something else I'm not seeing. The prop actually moves slightly up and down on the adaptor. Is there something else to tighten if I remove the QR...

Yep. Fully aware of the frame export in FCPX. I do a fair amount of image licensing and prefer to have as high of resolution as I can. It's fine for social media but a lot of times the images I sell are directly from posts on social media.

Thanks. I'm not interested in the lower resolution images so I'll stick with switching back and forth. Appreciate you digging into it.

Shoots stills in RAW, right? I'd bet you haven't updated firmware yet. Only thing I can figure based on my experience.