Recent content by DragonflyCameraSupport

We mounted the Connex ProSight to our insipre. See a few posts down. AVOID DSLRPros

Sure here are some notes about how we did it. -The camera was mounted to the front using the mounting bracket that came with the DSLR pros kit. (This was actually the only part from their kit we were able to salvage) -The transmitter was mounted to the tail end of the aircraft using dual lock...

Ok, thank you for your help. The motor turns freely, so I agree its likely not a bearing issue either. Do you have any suggestions as to the best place to source motors?

This aircraft is only 1 month old, never crashed, never hard landed. I agree a bent shaft seems to make sense. Do you know if its possible to get a replacement shaft?

Hello all, I am working on tweaking our Inspire pro with the aim of reducing vibrations down to the absolute minimum. While balancing the props, I also checked them while mounted to the motors verify that they were in plane. While my props all seem straight (+/- 1/32 of and inch or so) I...

I would like to second this. We ordered the Inspire FPV system from DSLR pros and it was total garbage, utterly useless beyond 100ft. They also sent us a different monitor with the kit than was advertised, which promptly died on its first job... Complete waste of money, I'm not even going to...

Hello all, We are experiencing a bug where the camera constantly resets to AUTO. Please see below for our configuration. -Dual operator -Camera settings settings typically set by slave controller (always set to Manual) -Shooting 4k UHD / 24fps (although it seems to happen regardless of...

Has anyone made any progress on understanding this issue? We too have seen subtle flicker when shooting UHD @ 24fps in full manual under daylight conditions. It makes the camera almost unusable for us. We have nearly 16,000 invested in a completely decked out inspire RAW package with all the...