Recent content by Flying High 1

Yes I looked into this but it had two problems 1. Flying with a cameraman on iPad mini 4's. The camera iPad was not receiving video picture 2. There is a speed limit in the geofence that can not be above a certain speed (can not recall the amount but it was not fast enough for our project)

We are not interested in a cage. Just setting a defined area and height that the drone can not leave. Just like the max distance and height function in DJI go 4 but being able to make it a rectangle

It is a requirement to operate at a sensitive site. While the radius/height option will work, it is not so convenient for the proposed flight paths

Hi folks. Is it possible to geofence an Inspire 2 to a rectangular or user defined shape rather than a simple radius/height option. Thanks in advance for advice

Well I found the issue finally. The problem arises when downloading on a mac. If the zip file has been downloaded before the mac will put a version number on the end of the file This is how it should look after unzipping WM610_FC550R_FW_V01.09.01.30.bin This is how it looked when it did not...

An update on my firmware issue. The camera mentioned above at the start of this thread was replaced under warranty as it went crazy on startup and lost its heading. I never got the firmware updated before it went crazy. Unfortunately the replacement camera is also being stubborn and will not...

Hi Folks I did use the manual focus slider with numbers showing at which point you were focussed. Useful for close up shots and making sure things were still in focus when you went wide. I use an app on my phone to double check the settings with regard to inputting the focal length, aperture...

Hi Jwffvm Thanks for the feedback. I have flown and the footage is OK. However I have also noticed that the camera is off by about 5 degrees when resetting it to straight ahead. A real problem when flying without the cameraman. **** frustrating. I have never plugged the camera in via USB...

I was semi aware that the level is taken from the compressed H.264 720P video sent to the tablet. What do you mean by "zebras are actually taken from the tablets 100% level" Thanks again for the input

Thanks for reply, I would like to know at what level the zebras appear eg 70%, 85% or 100% Looking at the Histogram it seems to be less than 100%, maybe 85% The histogram is so small its hard to know for certain. Thanks

Note: Correction to my previous post Just checked the Micro SD card after trying to go back 1 version of firmware and this message was on file "Result: Abort. The firmware on the SD card is identical to or older than the current firmware on the aircraft." When I tried to load latest firmware...

Hi Folks, I have fitted a new X5R to my Inspire 1 V2 Raw. The Inspire is on Firmware 1.9.1.30 The camera is on Firmware 1.8.1.40 The Go App tells me on the start up page that the camera needs a firmware update. I go through the usual process of loading the Micro SD card with the latest Bin...

Hi Folks, Can anybody tell me or point me in the right direction for documented information on the zebra levels shown in the DJI Go App. I am finding a lot of conflicting information. FYI I am flying an Inspire 1 V2 RAW. Thanks in Advance

Hi Editor and AeroMirage. Thanks for your suggestions. Got around to trying again this evening. Turns out the controller was not on the latest firmware and would not talk to the master remote. Interestingly enough I could make it the master. Now I have the UK Tx's as master and camera, the...

Hi Folks, I have a UK sold Inspire 1 V2 Raw with dual remotes. I have access to a USA sold Controller which I would like to use as an additional monitor for the client. The UK master controller and the USA controller do not seem to see each other when trying to link them. Does anybody have...