Recent content by HeliEngadin

Just contact us, we can regenerate them professionally with brand new, custom made cells, and TB48 will have an internal heater for cold climate operation.

Hello, we have been working months on regeneration of TB47/TB48, even the "S" and "D" variants for Matrice 100/600, and had a custom production line set up just to manufacture the cells by our own design. Chinese cells on the markets are mostly similar and don't balance out, we wasted a lot of...

Hello everybody, the KopterMax TB48K is made from an old DJI TB48 that is either exhausted, not performing well, with swollen cells or even not powering up at all. The original circuit board is preserved, and brand new, high performance cells are installed. In our laboratory here in Switzerland...

A M A Z I N G !!!

No. Apart from the hub thickness, the overall blade length would result smaller, highly impacting the performance.

This is actually a good point. The design for the Inspire 1 props is quite old, and at the time it was a quite standard one. The required lift for the Inspire 1 is pretty low, so getting it from the carbon props requires a small area and low pitch. Using bigger props would generate too much...

Hello, we are the official distributor of KopterMax in Switzerland and Europe.This thread only came to our attention today. We do think you received a defective set of propellers; the problems you mentioned are not common at all. Also the front prop touching the gimbal mount is an issue with the...

Well, Michael has always been a strong partner, but he did not confirm his last order yet. We have some sets reserved for FDS, so as soon as they confirm we will supply them. Or you can order directly through heliengadin.com Regards,

Hello, just to add our technical help on the point. We do produce folding carbon fiber propellers for Inspire 1 and 2 from long before TMotor entered this particular market niche. Our design for the Inspire 2 contemplates the use of nylon locknut embedded in the lower hub, but the most important...

Hello everybody, First of all Thank You very much to all our customers who support us daily. We always do all our best to satisfy your requests and provide a safe and tested product. We generally do not intervene in the various blogs, even when incorrect things are written... We just prefer to...

We have daily relations with Finalnd, since we supply in worldwide exclusive contract a cut-off engines specifically designed for Inspire to Skycat (PARACHUTE LAUNCHERS) whose headquarter is located just in Finland. The batch includes our flight terminator and their parachute with proper...

Screw-on quick release is a potential issue, since Inspire motors can brake with enough torque to unscrew the propellers from the hub... The solution I linked is actually fixed with 2 screws too the motor bell.

DJI propellers aren't carbon fiber, but some kind of carbon reinforced plastics. The quick lock mechanism is also prone to failure, as we all know. The cheapest and safest option would be 14" rigid full carbon fiber blades with rigid mounts. Inspire 1 Carbon Fiber propeller adapters

Hello everyone, we are a small company based in Switzerland producing precision parts for UAVs and drones in general. Since all the issues noticed with Inspire 1 and 2 propeller quick locks (ended in lost props sometimes), we decided to produce our own carbon fiber propeller adaptors. We...

Drone parts and aerial services