Recent content by InspireUser

The log shows all previous attempts, that was when I was messing about trying to get this sorted. If you read the log from bottom up you can see the most recent attempt where it did not have multiple bin files on the SD card.

I tried to downgrade again seems to do something but the problem persists. Log files attached.

I did try that and it made the d-d-d-d noise for a short period, when checking the log on the SD I see that it might have downgraded some of the items but not all. After clearing the log and trying again it shows that its the same version or lower message. Doesn't seem to fully down grade.

Yes sir apparently completed successfully too. On that same screen where you can see the current reported values I see nothing but 0 for the compass even when moving the ac in all axis.

Thanks, I have had a look at this and see nothing wrong with them. I have also ascertained that the cables connecting to the vibration plate are fine. I see the same issue even when powering with the gimbal not connected. I know there is communication happening between the two as when I power...

Hey all. I have an inspire I'm working on. I performed the update following the directions and it completed with success confirmed in the log file on the SD. Now when powering it up I get the craft initialize blink of all colours of the Leds the gimbal initializes and then points ahead. About...