Recent content by Kiwipete88

Here’s my best friend.

Look on the back of the rc, after the serial number is a letter A,B or C, the C type came out with the V2. If the slave rc is C type as well I don’t see why it wouldn’t work. my I1 is on the latest firmware along with rc and focus wheel.

The I1 Pro V2 has the C type controller, so the canbus has 5.5v at the plug, so the FW2 fits and works. So which FW are you using to control zoom on the 175mm?

I used an iPad Air 2 for a few years and have just crossed over to the CS ultra, C1 configures the same on both devices. Make sure you bring your drone to Queensland, some beautiful costal scenery over that side of the island. If you like seafood, try mudcraps and bugtails, yum yum.

Mine is setup with one click on the C1 button will toggle between pan & pitch on the camera.

I have recently fitted the focus wheel 2 to my I1 Pro,One click on the lens button changes from focus to aperture, apparently another click to the lens button changes to zoom mode but from my understanding zoom will only work with the Z3 camera, hopefully someone will prove me wrong. I don’t...

This mod is something I thought possible, so nice to stumble onto this thread & thanks all for the tips & tricks. My I1 V2 will get this mod eventually. I have recently purchased the focus wheel 2 mainly for using with the osmo X5 setup, but cannot get it to even power up, everything updated &...

It will more than likely be that one cell has dropped below 3V I had an I1 that did the same thing a few years ago. If one cell drops below 3v under load,the battery switches off.

No,that’s not normal,mine will correct horizon within 1 or 2 seconds at most. I presume you have calibrated the gimbal on a flat level service?

ND filters are used for video only,I use a clear filter for photography and keep ISO at 100 where possible.

Yep,that battery just ran out of gas alright,was hot to at nearly 70C. Same thing happened to me 18 odd months ago,fell from 10m,DJI replaced it under warranty. I now run auxiliary battery's with my TB47s and a parachute,touch wood have never had a problem since.

I have the inspire 1 V2, did an IMU calibration the other day after the latest firmware upgrade, it was around 6c outside. No problems to report.

DroneRepeat seems to work

Nice shot,we still have focus peaking on the inspire 1.

The same thing happened to my I1 X3 about 18 months ago,at that time it was written into the firmware that if a cell drops below 3v the battery switches off for protection (great) Healthy drones,now airdata showed a bad cell,this particular battery only had about 10 cycles on it,anyway I sent...