Recent content by kremat

Broadcast mode is supposed to send the signal that is stored on the SD-card instead of the stream for the pad. This adds some delay but the quality is supposed to be better. I can tell that there is this issue also with the cendence and SDI. terrible. no fast movements or pan allowed. Any...

I can see this bug on Cendence SDI out. Very annoying. Has anyone found a solution for it? Analyzing this bug, has anyone checked if Broadcast mode is real 1080i50 or if it is 1080PsF25 ? What will happen if I record 50fps?

Forgot to say that you should start and land in atti mode! Don't try it in GPS mode! You will fight the drone trying to hold the position while you are moving!

iOS

Hi, I have a big issue with the yaw motor. While panning continuously, the motor makes a short stop and then continues to pan. It doesn't happen when panning with the ipad, using touch. I put yaw on another stick, same error. The yaw is made for from slave remote and from iPad on slave remote...

Disable all landing gear automation, turn on CSC. Be very very careful. If you don't set it right and catch the body, the legs will come down before motors are off and cut your fingers. If set correctly, You can catch it with one hand. Then lower the legs manually with the remote.

Nope. The antenna is passive and can't communicate with the controller. Reminder: Never turn on or use the remote without antennas.You will burn the sending unit from the remote!

Set the fvp tilt on a button then you can tilt up and 45° down with one click. If you press and hold C1 or C2 (I don't remember), use the wheel to move the fpv cam up and down

Not much. You can turn focus peaking on/off, Center focus, recenter gimbal, push away the warnings. Using a Sun Hood, it is more difficult to use the screen. Using the buttons makes you work a lot faster, especially when someone else is telling you what to do. We bought it because of the patch...