Recent content by marc.horsform

No, it doesn't affect the Inspire 1's behaviour as far as you compensate the gap on the X5 UAV's support as I have indicated in my original post - but I've just noticed you found the answer yourself, SanCap! (I've been looking for these M2.5 motherboard's standoffs myself but couldn't find any)...

I was fed up waiting too and had to work with the thing. But I found a $2 fully working solution for dummies: I bought 4 M2.5 screws (10 mm long) and 2 nuts per screw as standoffs (= spacers). I drilled the thread of the nuts so they are just like thick washers. I replaced the 4 original screws...

At least your DJI Go app will show the correct version of the firmware in the «About» menu…

Everything's back to normal for me with the update 1.6.2.10.

Can't find it either…

I would definitely bet on that one… ;)

I didn't update the DJI Go app before updating the OSMO myself (because I had to do an urgent job with the Inspire and I tend to be careful when everything works alright with an older firmware…) But I've just updated the app right now and the «About» menu still shows version 1.0.1.19. The update...

Seems this temperature argument is fallacious: in all probability the 30 minutes limit has been implemented to avoid taxes in some countries where a legal difference is made between photo cameras and video camera (video cameras have higher taxes rates).

Same thing here. But nevertheless it seems that I have all the new functions of the 1.5.2.0 firmware. The firmware just doesn't show right in the menu.