Recent content by MarkPemberton

Just to confirm, the legs should look slightly bowed with the feet angled towards each other, Simons measurements would show you if they are off, if they are, then the screw is under a sticker (the warranty is most probably voided if you remove it) just loosed it a couple of turns and the leg...

Set everything up to your dimension and used your tip regarding lining up the props. Also realised I had broken one of the leg dampers, but with a cut down ball point pen for the tube and a spring on the end its good as new. The test flight went perfectly, in fact in atti mode it is actually...

Thanks Simon, That's just the information I needed, I'll set it all up and then when it stops raining here, take it to the biggest open field I can find (in case it's not quite in trim) for a test flight.

Just had a massivly heavy landing on my Inspire, the legs have rotated outwards at the T joints on the arms. I can see how to adjust and retighten them, but would like to know what the distance is measuring between the feet from left to right when in the travel mode and again with the gear down...