Recent content by Mikemal

Good point about the motor. It runs freely, is not old, has never had any damage, so you're probably right. It's a mission getting just the ESC, though, most vendors provide only a combination. Will investigate. Again, thanks for your time, and thanks for providing the software!

Right! That must drive you nuts when doing your software! So, the LF motor and ESC will need to be replaced. Just to make sure I've the correct culprit, please confirm my selection of the "correct" LF motor. I've included a pic. Sorry for sounding like an idiot!

Thanks, Bud, I appreciate your time. Can you confirm the orientation “Left Front” is as per DJI? As they look at the drone from the front, and determine the LF from that orientation, this confuses me a bit. The machine rolled left (as viewed from the back) if I’m correct here. If the DJI “LF”...

Hi Bud. Here is the dropbox link for the original dat file. Dropbox - FLY388.DAT Mike

Ok, will do. Home in about 44 mins.

Bud, here's the link. Thanks for the help! Dropbox - FLY388 data snip.csv

Excellent, thanks, Bud. I've snipped the file down to just the last 15 seconds or so, as it looks like everything was dead normal up until then. I'll dropbox it now.

HI all. I had an incident this week that almost resulted in the loss of my I1 V2. Fortunately I was in the hover at about 3ft high and it fell into grass, so no damage. In short, in P mode it suddenly rolled hard left and pitched, falling the 3ft in about half a second. I retrieved the DAT...

Could be. Surely the factory production line would not use the wrong stuff? Weird. I wonder if anyone else has had the same, or if this is a one-off?

Good idea, Ed. I'll give that a try. As you say, a temp fix, and I'll also tape it up tight.

HI all I removed my X5 camera to do some cleaning and I noticed that the plastic gimbal cover had become detached. I have no idea what would cause the three screw covers to have broken, leaving the cover free. I can only surmise that the screws were over-torqued during construction (it's a...

That's the best response I've ever read (the topic comes up a lot) - good job, and thanks for posting!