Recent content by purezerg

based on the triangle. I would say p3 or inspire only needs to ascend to 350m max to break free from it. probably 200-300m would be enough to break free from it.

what happens if you set RTH to ascend to 500m first? LOL

having the t600 and the B variant remote. but I added the long range antennas. maybe it's just me, but I don't see what's to get worked up about. thou mine is a x3 and I plan to get only the x5r. after investing in blackmagic ursa and a couple of prime cine lenses, I figured that RAW is probably...

not to be a show off. but this was shot at 3.1m height.

but the best angles are not higher than 120m. infact they are around 1-30m

any pilot cant that fly without GPS isn't a certified pilot in my opinion and thus should not fly in such areas. i wrap my GPS with tinfoil. not only is it flying faster, it doesn't have any restrictions. i keep a roll of tinfoil in my case just in case nearby pilots wants to give it a try. I...

one of the reasons to strap a field gas tank and practice mid air release cargo.

you have to consider that DJI is a china company. if it's a US company, I'm sure DJI would have to release the source code to the china to ensure further business operations in china.

what happened to the tin foil cap for i1? I have been using that method to fly for a long long time.

have you tested 17 and 25mm on the x5 yet? is it workable? I am planning on getting the x5/x5r but am held back by the limited 3 lenses

Press in = stock charger Pressed out =boosted charger

ya no issues. the last update to v1.3 I used a discharger circuit with the lamp. in mode 3, it discharge to 3.2v? I then proceed to charge all my batts in 1 go. so far so good. have done full charges for 6 times now. then again, I hardly fly. I use the p3 to practice and i1 when theres a job...

omg I just reread my post. countless spelling errors. only slept 4 hours in the past 70 hours. currently on a commercial shoot job, (non aerial) so I was just going thru my emails and stuff and spotted this message.so please bear with all my spelling errors.

forgot to mention, that splitter without the resistor is only ideal for original dji charger. it has a disadvantage. 3 batteries of different cell power, eg, batt 1: full discharged, batt2:40%, batt3:70% without the ceramic resister, the batteries are all linked. batt1 will draw all the power...

ok. I have both and I can pretty much tell you what they are. the button press in ( for original DJI charger) press out (for high amperage non DJI charger) the difference between the 2 ( with and without ceramic.) when using the high amperage power supply unit, without the ceramic resistor, the...