Recent content by Richard in ky

It depends if you can remember when they actually did have peanuts in them.

Is your Inspire 1 out of travel mode for some reason it has to be out of travel mode to do the update. I had a problem once when I updated my controller first while the Inspire was in travel mode. My memory is short but I believe without connecting the controller to aircraft I couldn't download...

I would try reloading Zenmuse Z3 Preinstall Firmware V01.09.01.30 on your SD card. I had about the same issue and that fixed it for my Z3 NOTE: Deleted all the old bin. files then copied Firmware V01.09.01.30 onto the SD card from the DJI site: Put the SD-Card back in the Z3 camera and turned...

There is a way to reset your battery by taking the top off, but I don't have the procedure, it is simple and on the internet. There was a video at one time. One of the new firmware's caused a lot of people's batteries to be bricked whether they were New or old. I had one that was bricked with...

Just a camera update for the Z3. And it did work with my osmo but it is night time so I really didn't get to test it very good.

Thank you for the post not sure why it isn't located under inspire 1 Z3 camera it just shows the Zenmuse Z3 Preinstall Firmware V01.09.01.30

I seen on my screen that a new camera update is needed but I didn't see any new update on the DJI site for the Z3. the newest firmware it shows was from August. How do I load the newest firmware.

Is there any type of adjustments that need to be done such has how does the screw jack know the upper limit doesn't seem to have a switch or anything.

I didn't have any luck getting the jack screw straighten enough so I am ordering a new center frame but the one I have looks just like yours with the 4 separate arms on the part that rides on the worm screw. All the ones for sale the arms look to be a one piece do you know if it was just a...

I believe you are probably right about the prop coming off and if it wasn't for the people saying it looked like it hit a bird that is what I would probably had Thought it was. I think they just saw the prop coming off and thought it was a bird. Thanks for your replies.

No I just tightened them down by hand and didn't use the locks so it is possible that it was my negalance, except for the people that claim it looked like it hit a bird and possibly that could have been mistaken for the prop falling off. Just wondering if hitting something could cause you to...

I was flying the Inspire 1 and it was about 200 ft high in sight if I was watching it instead of my display. While watching my display it suddenly started spinning and fell to the ground. By the time I got to it to recover it some people already was bringing it back to me, They said it was far...

I am in the process of repairing mine but I bought a new arm. I am concerned that on the old arm the shaft that hold both motors turn freely in the hub ( the cross member thing that connects both arms. My new arm does not turn that freely and takes a little force. Not sure if it is supposed to...

What I had to end up doing is link my Inspire 1 RC to my PH3 then it allowed me to degrade the firmware in the RC. Linked it back up to the inspire 1 got it out of travel mode then installed the new firmware in the inspire 1 and RC.