Recent content by RobUK

I'd rather crash my drone than get an "original" Enrique Iglesias Tee-shirt ... Please guys ... NEVER hand catch an R/C helicopter or Drone ... under any circumstances ... even when on stage!

It has been released on Android, I updated the firmware on my Google Pixel and POI mode is working well.

Legs tilted inward slightly, the props need to tilt outward at an angle of about 10 degrees

No its not the screws underneath each motor, you adjust the arm angle by slackening the clamp screw below the "Tee junction", you need a good fitting star driver.

Its the cause of the "instability" and you need to adjust the tilt of the legs so its exactly the same both sides, with rotor tips at the same height when you measure them against the body of the drone.

If DJI default settings are not the recommended ones from manufacturer, it would be strange?

You will definitely need to do VPS calibration after the X5S is attached. When / if you change back to the X4S you will have to do VPS calibration again. Also have to redo VPS calibration after changing any lens. I think the same firmware version handles all possible gimbals automatically...

@WillT@ Just trying to help here. I read a post (can't find it now) where another pilot had the same problem with his I2. It turned out to be an intermittent contact on a cable connector internal to the I2 that connects to the gimbal. The connector was unplugged, then plugged back in again a...

Same advice applies if it drifts sideways when pushing the stick forwards, check rotor tips are at same height ... adjust if not

Hi Rob, Any drift to either right or left while climbing vertically is probably due to prop misalignment due to one of the cf tubes having rotated slightly. Check this with heli on the ground, turn the prop blades so the tips are as close as possible to the body of the drone. The blade tips...

Sent you a private message with details. Many thanks, look forward to purchasing from you!

If you are interested to organise shipping overseas, I'd buy the Crystalsky from you and can pay using PayPal for your asking price plus shipping costs. Send me a PM?

HI Kiwi, As far as I understand your message, you are using the standard X5S gimbal with the I2 and the older X5 gimbal with your I, is that correct? Because the X5 will only work with the I1 and the X5S will only work with the I2, the gimbal are not interchangeable. So, which lens is giving...

Could you outline the equipment needed in addition to an I2 X5S to do power line and cell tower inspection work? I assume that IR camera is necessary, that thermal imaging is the main requirement? Which equipment do you recommend?

That's the exact same scenario where my landing gear stuck. Gear coming down and then you increase throttle. I believe it to be a firmware bug, but noone else believes it and I just get dissed every time I mention it. I wound the landing gear down using the screw underneath the I2 and have...