Recent content by Ron_Dog

Has anyone else had this problem? My antenna wires have broken off,(one in front-end one in the back). I re soldered them, but last week the rear left one broke off again? I tried to get as much slack as I could in the coaxial cable, before re soldering it. Can you buy replacement coaxial cables...

I would trust it! I try to land around 40%! This cuts down my flight time, but it is much better for the batterys,than draining them down too low. On occasion,I will get out too far and drop below the 40% level comming home, but I try not to make it a habit! .1 or .2 of a volt variation isn't...

The "ideal" voltage for storing lipo's is 3.8 Volts per cell. I know DJI has a chip to put the cells into "storage mode",but I just fly my Inspire (hover it) until I hit 3.8 V per cell on the battery display, then land it! Works for me!;)

Yup! You can bet the soon to be released, Mavic Pro 2 price just went up!

Is this the only battery you have? With only 17 cycles on it, it should do better than this? If it's a new Inspire/battery,I would contact DJI about the battery.

I would "cycle" the battery and see if the cells would come into balance. I cycle my batterys every 20 cycles (charge, discharge). I go out to the back yard and let the inspire hover until it lands, then just let it idle until it shuts down. Then let the battery rest at least 30 minutes (a hour...

Well,I found the problem! The antenna wires aren't soldered on the best, and 2 of them had came off the antennas! I cleaned the connections up and resoldered them (no cold joints) to the antennas 1 front right hand side the other rear left side! We then took the Inspire 1 out for a short test...

I purchased a used Inspire 1 and have experenced problems with the range, and dropouts! One time it would fly fine, then the next flight on the same flight path, it would loose connection? After much research,I found some owners had found "cold solder" joints on the antennas coming loose. I...

V 3.1.27 DJI Go iOS

I will do it as soon as possible,Ralph!I picked up my Inspire used, and the guy I got it from used a Android tablet, and said he never had one problem with it. What concerns me is, that with DJI comming out with the Mavic Air,and now the soon to be released Mavic Pro 2,I think everything else...

I'm going to try it with my Nexus 7 (2013) Tablet this week. I also fly a Mavic Pro,and it hasen't had any problems so far with the latest iOS update? This almost make me think there's a problem, with the Inspire's firmware? I will know shortly! My iPad 4 Mini is running the latest update 11.2.6...

I can't figure out why I get good reception one flight, then the next flight along the same flight path,I have the signal drop a lot of diffrent times. It's kinda driving me up the wall. It dosen't make sense? The worst part is,I'm out in the middle of no where, and still get the strong...

Thanks,Donnie!

Donnie,one more question? I don't have a PC. I use a Mac, will this work on it?

Can I down grade from V 1.11.01.50? The Controller is on V 1.7.80