Recent content by RoryG

The standard RC will work while charging, the Cendence has a hot swap battery so you can change it, although if you’re live streaming it would still cause an interruption. Never tried plugging the Cendence in whilst flying.

Hi Donnie, thanks for the detailed reply. The cam op uses a high brightness Atomos monitor / recorder that the director / DP can also view, and we record on it for immediate playback after each take. We don’t have any googles but it’s an interesting idea! We have all the backup kit so can...

Thanks Donnie. I had changed the standard slave controller to a Cendence with CrystalSky, and used a CrystalSky on the master when the problem first appeared (before that I was using a Cendence with an iPad as the master). Using an iPad seems to cure it but I only have one screen mounting...

I'm having a major video issue with my Inspire 2 with Cendence master and slave and two CrystalSky 7" screens. Basically on one of the devices the video is broken up with a huge lag, although all controls are responsive. This doesn't happen every time, but more times than not. On the slave...

I'm interested in the one without the patch antenna - I've sent you a message

UgCS supports the Inspire 1 with the XT payload

Paul Leeming has created a universal LUT for Panasonic cameras (he’s also working on one for the X5S) that works well on dlog. It’s not perfect but it does give you a fairly accurate Rec709 base to work from without creating too much noise. Check it out at Leeming LUT One Cheers, Rory

I've been following this thread with interest (and on other forums out there) and still looking for more than anecdotal evidence about the slow down / reduced power with 1.6. I'm running 1.5 in cold weather without issue, but I do warm my batteries to at least 25ºC prior to heading out, and keep...

I'm sticking with 1.5 for the moment. The temperature here will not normally reach even 8 or 9°C until April, and the best I can hope for is 15 - 20mph wind. I always warm my batteries in an insulated bag with a microwave cosy so they're usually about 18 - 25°C when I put them in, along with...

DJI want to keep an eye on their wiki then, as it clearly states the Go app will display the aircraft upgrade progress (which it doesn't): Inspire 1-How to Update Firmware - DJI Wiki Never had an issue updating any DJI products with the exception of a V1 H3-3D that needed the jumper trick to...

No issue here, I already had flashed the RC so it was just the aircraft and batteries. Went to no signal during the aircraft upgrade but all fine after reboot. Loving the gimbal yaw smoothing and finally being rid of the synchronous yaw :) 40mb/s at 1080/30p is welcome too...

Here's a question, what happens when the airport is located at the bottom of steeply sloping ground? Here's a map showing the DJI no fly / restricted height circles and another showing the hill by the airstrip in Foula, Shetland. I plan to film here next summer. As the FC/Go App is only aware of...