Recent content by Rutchmann

agreed and most importantly the motor arms where you have a node in the middle (t-junction) with rotating mass at both ends...and you wont be able to dampen the resonant vibration unless there is direct contact, with some pressure, to damping material, i.e. the rubber pads on the bushings. The...

I used layers of electrical tape as the shim and just kept adding layers until the play was gone but, per Rob's suggestion, the motor arm could still move freely by hand with the control arm removed (not sure why but I didn't remove the warranty sticker, just poked a hole in it to get the...

confused by ATTI gains still...I have the option to change three separate parameters under an ATTI section in the advanced settings...advanced, gyro and vertical

Thanks mucho for this...I did exactly this and fixed the problem like a charm. I appreciate your willingness to take a risk and crack it open

did anybody read the article...he was smuggling drugs into the prison with the drone...o_O

sorry if someone has asked already but have you looked at your accelerometer readings when its on deck?...just curious to see what these levels are and if one could determine a threshold where it would allow you to start the motors. Would be a good starting place for a firmware revision by DJI...