Recent content by tanakan

https://www.avito.ru/novosibirsk/audio_i_video/motornaya_chast_osi_yaw_wm_610_dji_zenmuse_x5_1620906739#extended

whole story - After hard landing, yaw motor broke. I fixed yaw shaft, changed both connectors between Inspire and Zenmuse (wm610 gimbal connect and wm610 yaw connect v3) Gimbal was still completely dead, app says it was not connected, gimbal was limp and there was no video feed. After that I...

that would be great. I can't find any info about differences between x3 and x5 yaw driver board on internet. Here is the picture of the back of pcb, "WM610 Gimbal Driver v2". If you can compare with the one you got, it would be great. And Droneted you're life saver for the second time :)

Topic updated with new needed part. thanks

If you have multimeter , you can check flat cable inside of the gimbal... I thought it could be a gimbal connection board on inspire problem, but since the same behavior is present on osmo I would rule out that option. You will have to remove bottom cover of x5 (5 screws) and check both ends of...

Hi Calde315, I'am writing about WM610 YAW CONNECT V3" pcb board. Did you manege to find one? can you tell me your price with calculated usps airmail shipping costs to Serbia, Europe? thanks in advance

I just PMed you

Thanks for moving. Location is Serbia, Europe

Im looking for a spare board that sits on top of YAW motor on Zenmuse x5 and x5r WM610 Gimbal Driver v2 this was topic for my old thread, where I looked for yaw connect board which i successfully bought from user DroneTed (great guy) I know this thread should probably go to Classifieds...

Yep Jim, you're right. it's all good with arms, I have tested bird without camera and it fly great. Now, to fix X5, I managed to weld yaw motor but it seems that connection board is also dead and it can't be found anywhere as a spare part. Only place where I could find it don't have stock and...

I recently crashed my Inspire 1 Pro x5. Broke pan motor on x5 (currently welding it with glue, hope it will work). During diy repair process I noticed that booms are not aligned, right arm is about 8mm more up front than left arm, please see pictures attached. Im not sure is this normal or is it...