Recent content by VisualPoets

Ralph @ FlyHigh USA makes 3D printed top mounts for the Crystal Sky monitors—for a SmallDH to be mounted for FPV. Here is a video where you can see it as we have set it up. The SeaCraft tray gives all the support you need. Very balanced.

Sorry for your troubles. The lens mount seems to have some issues. On my X7, I have to rotate fully clockwise to seat, then back off counter-clockwise or my unit will not engage recording when we hit the software record button. Image looks great however, just cannot record. When I rotate...

It is not a firmware issue. It is a contact issue. In fact, ours will sometimes not engage recording in flight if the lens is not making all contacts. After lens change we have to slightly rotate counter-clockwise as mentioned to ensure pin contact. Must be very narrow tolerances for...

Sounds like good input and strong feelings on both sides. Here is our personal experience and what we’re doing. Must admit I still have a slight lump in my throat on many of my flights (often over water) reguardless of prop choice, maintenance, battery checks, etc. I’ve flown too many...

I had to make a phone call to DJI. Whoever I talked to took all my information and said by the next day I should be able to transfer it via DJI assistant software. Had to prove purchase. Also needed serial of crashed I2. It worked and no 6 hour drive : ) But is SHOULD be as easy as...

That's pretty amazing Phil! Glad you are still flying and didn't even have to replace them : )

Hey, let me throw in my two cents since I have actually hit things with CF and stock blades on my I2. Not proud of this but...I was flying with the Tmotor folding winglet carbon fiber props on the west coast near the ocean and was rising up when I caught a high tension power line (about 60' up)...

Olympus 12mm and 45mm are your best combo! Effectively a 24mm and 90mm with the cropped sensor. The 90mm makes you Michael Bay. But you really need a second controller and camera op. The 45mm is very hard to control without practice. But the results are stunning. Always run both with...

I have done the same as @Eric but one must be very careful. Started doing when landing surfaces were just too difficult to land. I lower craft to a couple feet, landing gears down and grab over the top onto GPS dome, then cut power with left hand on left stick. Only once did I have a near...

Just a quick comment about catching the Inspire 1 or 2 verses the Phantom. Yes, the Inspire is a lot more craft to grab, especially as a solo act...but we do it all the time. But one cannot take this act without precautions. Always grab it from above...not below! Bring the Inspire to a hover...