Recent content by x-tremephoto

Each time try to update the firmware (which takes appr. 1 hour) I notice the camera gets pretty hot/warm. Is that normal?

Thanks crashburn!!! But do you mean AlexanderAF?

I am also in desperate need of the "magic firmware update" file. My kingdom for (a horse) THE MAGIC FILE!!! I will give you my first born male child!!

A bit far from Chicago :) I'm in Bakersfield CA Your offer is very generous just the same and I thank you tons for your efforts and encouragement! I'll give it another day before sending back! Thanks again.

no success trying to relink. :(

I'll try that :) thanks !! I did get the screw to turn and was able to get the craft in to travel mode manually. Small success.

NOW the screw under the craft which is supposed to move it into "travel mode" manually won't budge!!!!!!!!!!

cleaned everything off it but the bin file !?

Yes, I found this also a day or so ago. Sadly, I only have the single controller ( no slave and master). Again, thank you, ever so much for the find. It looks like I'll have to send it back. However, it won't link up to put back into travel mode, so it won't even fit back into the box! GOOD...

Not yet, still working on it. Thanks for asking!! :)

I just off the phone with tech support in LA (after waiting on the phone for 40 min.) Talked with Mark. Mark looked up the error code of RC FPGA with absolutely no suggestions for a fix!!! His has instructed me to send it LA and they will fix it with a turn around time of 5-6 WEEKS!!!!!! Still...

ThatShotr, did you get the "RC FPGA" error

Thanks "ThatShot", I will try that as soon as I get home from work today and I'll let you know how it goes.

Thank you Kilrah. Yes. I have tried two different micro chips and a USB memory stick with no success. I also searched the actual error code ( RC FPGA error ) on the DJI web site to look for a solution, again without success. I then sent the question to the DJI 24/7 tech support (which is a...

During an attempt to update my new Inspire 1 and transmitter, I mistakenly turned off the transmitter while it was trying to update (blue light showing). Now all I get is a blinking red light and a very annoying constant beeping! The manual refers to this condition as a "transmitter error" but I...