Recent content by ZENUAV

I assume the post had a video of a flight, which used the SDK and was not a video of the SDK code used to do the flight. I don't think that's a breach of the developers NDA, what information has this disclosed to you?

Also, always set your RTH Height higher than you think in case the drone drifts behind something you where not planning on flying behind and starts a RTH.

Hello Mark Just before your Inspire 1 takes off, it sets it's altitude to zero. When you go to say 10m, that's just from the 0 position. Moving along an uneven ground will not change the altitude reading, so be careful. Likewise, when you take off from the edge of a cliff, hover at 10m they...

It's possible. So many combinations, so many different results. I would still ask the app developers if they have updated there apps to work with 1.3 and then firmware versions you are using for rc and drone.

If the DJI App shows the correct battery % then all hardware/firmware is working. It must just be the 3rd party apps??

The Inspire 1 firmware to support POI is still in Beta. Something we are all waiting for final release.

The 3rd party apps must need updating to support a change in firmware 1.3. You will need to chase them on this problem, not DJI.

The SDK does not allow you to extend the functionality of the DJI Pilot App. It will allow you to create a new app from scratch. It's a huge amount of work just to get to a basic app that's safe to use in my opinion.

Yes, the documentation is non existent so it's a case of building your app in small blocks with a lot of trial and testing steps. What's your plans??

I also cache location maps while at base!

I would add 'and prop locks' to point 11.

Hey Gary! Your not too far away, especially if we only meet up every few months! :)

No, I don't think so. I'm away next weekend, but the weekend after might be a good time?

I'm using the latest version and 16gb seems more than enough. Also its wifi only, so I just cache the maps before I set off. You can also heather it to a mobile to get onsite maps too.

Hi Harry I'm up for that! I known one other lad from near here, so I'll ask him too.