Successfully downgraded inspire1 v2 from 1.11.01.50+ to 1.08.00 and rc from 1.7.80 to 1.6 using the debug file method. However, on Startup, the gimbal goes through the motions and then goes floppy and will not respond to movement or commands, but the camera itself still works. Going back to 1.11.01.50 resolves this issue.
does anyone have an idea why this would be so? Also my camera version only goes back to 1.10.xxxx but the original camera (I crashed) shows v1.11.01.50+
in addition, I can’t seem to calibrate the compass in 1.08.
does anyone have an idea why this would be so? Also my camera version only goes back to 1.10.xxxx but the original camera (I crashed) shows v1.11.01.50+
in addition, I can’t seem to calibrate the compass in 1.08.