Welcome to InspirePilots.com

Join the leading DJI Inspire community for free!

DJI flysafe Geo update and unlocking areas

Discussion in 'Inspire 1 Help' started by Firefly_AI, May 16, 2016.

  1. Firefly_AI

    Joined:
    May 11, 2015
    Messages:
    41
    Likes Received:
    16
    Apologies if this has been posted before.

    Flying in UK. On latest FW (Inspire 1 Firmware v1.8.1.00). Downloaded the geo beta app on android and unlocked a restricted area (Coventry, Ryton). Area shows in the app as a valid unlock but when I go to arm the inspire, it says I am in a no-fly zone and won't arm.

    Do I need to download the beta aircraft FW also (Inspire 1 Beta Firmware V01.09.01.02)? I take it this would be across all components (batteries, TX etc..)

    I have a job on Wednesday and need to get this sorted!

    Any help or experiences would be very much appreciated.

    (we have all permissions in place for this; ATC, police, landowner and Air Ambulance)
     
  2. Canuck32

    Joined:
    Apr 30, 2015
    Messages:
    104
    Likes Received:
    33
    Location:
    Alberta, Canada
    RC doesn't need update, just the inspire needs update to get FW. never hurts though to check other batts in case they are on old FW.
     
    Firefly_AI likes this.
  3. Firefly_AI

    Joined:
    May 11, 2015
    Messages:
    41
    Likes Received:
    16
    Thanks. Have two jobs tomorrow, so think it wise to get these done and dusted and then worry about the update. I'd rather get a test flight in following an update than just go straight into it. I also can't risk locking out anything for tomorrow...