Inspire 1 pro. X5
I had image transmission issues and worked through the suggestions on inspire pilots. I am sure it is the firmware and liked the post from jussaguy who talked about emptying the cache. So I downgraded the RC to 1.58 but couldn't do the same with the aircraft which i could only update to version 10. I also updated my 5 batteries.
I then updated the rc back to version 1.6.
Each time it appeared that I had done the right thing and the reports showed success and the RC showed solid green, but the aircraft was always saying it was disconnected. I didn't worry too much as I knew I could link it with the red button.
OK so now I have updated the firmware on both and tried to link the aircraft to the RC but no joy.
Questions I have and I must say the user manual is as clear as mud,
When updating the RC (and the manual doesn't tell you this) where do you connect and how do you connect the mini USB lead to the aircraft?
I have used the mini USB port on the RC and connected to the port on the rear of the aircraft and not the port on the camera. Is this the right way?
Secondly, is. There a technique for pressing the red button? Am i supposed to hold it down for a period of time?
Am I supposed to do a waggle dance that is known only to some remote tribe in Outer Mongolia?
Speedy help would be appreciated as I hope to use the beast tomorrow!
I had image transmission issues and worked through the suggestions on inspire pilots. I am sure it is the firmware and liked the post from jussaguy who talked about emptying the cache. So I downgraded the RC to 1.58 but couldn't do the same with the aircraft which i could only update to version 10. I also updated my 5 batteries.
I then updated the rc back to version 1.6.
Each time it appeared that I had done the right thing and the reports showed success and the RC showed solid green, but the aircraft was always saying it was disconnected. I didn't worry too much as I knew I could link it with the red button.
OK so now I have updated the firmware on both and tried to link the aircraft to the RC but no joy.
Questions I have and I must say the user manual is as clear as mud,
When updating the RC (and the manual doesn't tell you this) where do you connect and how do you connect the mini USB lead to the aircraft?
I have used the mini USB port on the RC and connected to the port on the rear of the aircraft and not the port on the camera. Is this the right way?
Secondly, is. There a technique for pressing the red button? Am i supposed to hold it down for a period of time?
Am I supposed to do a waggle dance that is known only to some remote tribe in Outer Mongolia?
Speedy help would be appreciated as I hope to use the beast tomorrow!