Welcome to InspirePilots.com

Join the leading DJI Inspire community for free!

I1 Gimbal Pinout

Discussion in 'Inspire 1 Discussion' started by qbizzy, Jun 9, 2015.

  1. qbizzy

    Joined:
    Mar 5, 2015
    Messages:
    78
    Likes Received:
    40
    Location:
    Orange County, California
    Has anyone tried to make any camera mods in place of the gimbal? If so, have you mapped out what each lead does? I can 3d print a fixed gimbal but wish I could make an adapter plate that will work with my FLIR. If that makes any sense.
     
  2. Kilrah

    Joined:
    Feb 3, 2015
    Messages:
    1,881
    Likes Received:
    728
    That's a few months of full-time work from a dedicated engineer you're asking for there :)

    There's a company that said they were working on that but it was about 6 months ago and no news.
     
  3. Ned Clark

    Joined:
    Jun 9, 2015
    Messages:
    1
    Likes Received:
    0
    Guys
    I'm involved with fixed wing IR units and would really like an Inspire with a Flir.... What about the Seek?
    It gives raw data and is really small... I'm not sure about actual temp readouts as we are just working with it now but I think it should work.
    Ned