Something bizarre happening with my Inspire/Zenmuse x5. The gimble when connected to the aircraft is vibrating really rapidly and strongly. Also hear a "grinding" type noise coming from it. (Similar to the noise it makes when booting up) I did not visibly notice this issue, it was only after reviewing multiple videos with strange lines and rapidly pulsating jello that I started looking into the problem. No error messages appearing during operation. Moved the x5 over to my Osmo...no vibration. (Though the fan is not automatically turning off on record now). Called DJI CS. Did the usual checklists: Firmware : Current IMU: Reset Gimble Calibration : Reset and Complete. Anyone else run into this? Solutions? THIS IS NOT A PROP ISSUE. Thanks so much fellow Pilots!