Welcome to InspirePilots.com

Join the leading DJI Inspire community for free!

Landing Gear Bent Part

Discussion in 'Inspire 1 Help' started by Dan Dobbins, Nov 7, 2015.

  1. Dan Dobbins

    Joined:
    Nov 1, 2015
    Messages:
    7
    Likes Received:
    0
    I crashed my I1 and have one broken motor arm to repair. I also bent the metal yoke that translates up and down the shaft to transform the gear, so one gear side is higher that the other. Looking for a replacement metal yoke part and the grey plastic part source and instructions to disassmble this area.
     

    Attached Files:

  2. Alastair

    Joined:
    Jul 15, 2015
    Messages:
    276
    Likes Received:
    62
    Location:
    Prince Edward Island, Canada
    Any details on what caused the crash? Sometimes we all can learn from people's misfortunes. Sorry to hear about yours. You might have to end up sending it back to DJI for the arm replacement. There is a jig that they use to properly align the arms.
     
    #2 Alastair, Nov 7, 2015
    Last edited: Apr 7, 2016
  3. Dan Dobbins

    Joined:
    Nov 1, 2015
    Messages:
    7
    Likes Received:
    0
    The crash was at 100 feet altitude when the pilot flew into trees
     
  4. Alastair

    Joined:
    Jul 15, 2015
    Messages:
    276
    Likes Received:
    62
    Location:
    Prince Edward Island, Canada
    Ah, that's too bad. You might find parts on eBay and be able to repair it but the alignment is a critical part of it.