More Problems after update - video

[dkotinsky]

See videos below

 

[dkotinsky]

 

[dkotinsky]

 

[dkotinsky]

X4S Flopping Around and making Scratchy Noise:

 

[NickU]

Turning one is easy, nothing to do with the firmware update other than it's probably adjusted a setting for you - go and adjust your Gimbal settings. Covered it before on here -> Stick Sensitivity - Yaw Control.

 

[dkotinsky]

Turning one is easy, nothing to do with the firmware update other than it's probably adjusted a setting for you - go and adjust your Gimbal settings. Covered it before on here -> .

And the Camera?

 

[NickU]

Can't really say about the camera - haven't experienced that. Only thing I could suggest is to do a forced firmware refresh using Assistant or DJIGo frmware page.

 

[dkotinsky]

Can't really say about the camera - haven't experienced that. Only thing I could suggest is to do a forced firmware refresh using Assistant or DJIGo frmware page.

done factory reset, then reinstalled firmware with dji assistant 2

 

[EDDSkitz]

Can't really say about the camera - haven't experienced that. Only thing I could suggest is to do a forced firmware refresh using Assistant or DJIGo frmware page.

There's obviously broken firmware of some sort going around... not everyone of course, but plenty of us..

Mine does everything just fine, but the noise and shake at startup, and the extra YAW noise and vibration in the video is there.

Wondering if the people that say they have no issue just can't hear it (it's quiet and the fan is loud), or haven't looked at a recorded video.