Welcome to InspirePilots.com

Join the leading DJI Inspire community for free!

No Atti mode?

Discussion in 'Inspire 1 Discussion' started by BrianSelf, May 2, 2015.

  1. BrianSelf

    Joined:
    Jan 14, 2015
    Messages:
    72
    Likes Received:
    16
    After the most recent update, I cannot switch the Inspire to ATTI mode, it only stays in GPS unless it looses actual GPS connection???

    Anyone else experiencing this?
     
  2. The Editor

    The Editor Moderator
    Staff Member

    Joined:
    Aug 7, 2013
    Messages:
    6,705
    Likes Received:
    3,862
    Enable multiple flight mode in the app (same as before this update) and like David Copperfield, Atti will magically return. o_O
     
  3. GizaDog

    Joined:
    Jan 15, 2015
    Messages:
    485
    Likes Received:
    234
    Location:
    San Diego
    LOL and Copperfield is still alive too! :p
     
    The Editor likes this.
  4. BrianSelf

    Joined:
    Jan 14, 2015
    Messages:
    72
    Likes Received:
    16
    Ohhh okay, I figured I was missing something I did earlier before the update. Haha well thank you very much good sir
     
    The Editor likes this.
  5. The Editor

    The Editor Moderator
    Staff Member

    Joined:
    Aug 7, 2013
    Messages:
    6,705
    Likes Received:
    3,862
    Only just!
     
  6. RGD

    RGD

    Joined:
    Mar 29, 2015
    Messages:
    80
    Likes Received:
    12
    I am an airplane pilot and pushing the stick forward to clime has conflicted with my motor memory a little. I changed the controls so that you pull the stick back to raise the aircraft. It works fine but now I can only use the auto takeoff function. I can no longer pull the stick together and back to start the motors. What am I missing
     
  7. The Editor

    The Editor Moderator
    Staff Member

    Joined:
    Aug 7, 2013
    Messages:
    6,705
    Likes Received:
    3,862
    Because you have changed the stick mapping you can no longer initiate a CSC to start the motors. Unless the flight controller 'sees' the stick travel to 100% down and left/right on the left stick and the same but opposite corner on the right stick the motors will not start.
    What you have done is make the flight controller see the opposite input on the right stick.