Welcome to InspirePilots.com

Join the leading DJI Inspire community for free!

No signal, FW 1.9.1.3, Cam 1.8.1, TX 1.6

Discussion in 'Inspire 1 Help' started by Winston, Jul 10, 2016.

  1. Winston

    Joined:
    May 2, 2016
    Messages:
    25
    Likes Received:
    3
    Just rebuilt my damaged Inspire and attached the new X3 camera to replace the water damaged predecessor.

    Started up for first time, firmware update required - so did the update. Now GO app is saying everything is up to date (if I try to do another update I just get a continuous beep). Now I am connected to the aircraft but no signal / video feed.

    Any suggestions?
     
  2. Leszek Kedziora

    Joined:
    May 22, 2015
    Messages:
    82
    Likes Received:
    23
    Location:
    Warsaw
    Try to put up with one hand the drone and switch 3 oraz 4 times the lever on the remote. Then restart the drone.
     
  3. Mad_angler1

    Joined:
    Dec 9, 2015
    Messages:
    439
    Likes Received:
    159
    Are you getting telemetry ?

    Can you arm the motors ?

    What FW is both the craft and the controller on ?
     
  4. Winston

    Joined:
    May 2, 2016
    Messages:
    25
    Likes Received:
    3
    Thread title has it all.
     
  5. Winston

    Joined:
    May 2, 2016
    Messages:
    25
    Likes Received:
    3
    Have flight controls. No video feed and now the camera has started doing a death spin.