Welcome to InspirePilots.com

Join the leading DJI Inspire community for free!

Remote controller firmware update

Discussion in 'Inspire 1 Help' started by jonathnsmith, Jan 14, 2015.

  1. jonathnsmith

    Joined:
    Jan 12, 2015
    Messages:
    76
    Likes Received:
    44
    Location:
    Chattanooga, TN
    Just got my inspire and updated the firmware on the drone with no problem. However the controller won't update no matter what I do. I've followed the steps in DJI's guide repeatedly with no success. Tried to contact their live support but they ended the conversation with a screenshot of the guide after telling me to format the card which I did but couldn't tell them since they ended the conversation. Currently 40 minutes on hold in their customer service number.

    I've tried a Usb drive, a card reader and the gimbal to update the drone with no success. Anyone run into any issues with this?
     
  2. jonathnsmith

    Joined:
    Jan 12, 2015
    Messages:
    76
    Likes Received:
    44
    Location:
    Chattanooga, TN
    Update. I left the controller plugged into the gimbal for an extended period of time and it finally worked.
     
    #2 jonathnsmith, Jan 14, 2015
    Last edited: Jan 17, 2015
    DjiQuadzilla likes this.
  3. noazeb

    Joined:
    May 14, 2015
    Messages:
    1
    Likes Received:
    0
    Hey Jonathn did you have the gimbal attached to the drone and the drone turned on>?
     
  4. ESC21

    Joined:
    May 14, 2015
    Messages:
    13
    Likes Received:
    0
    I did two remote controllers yesterday.

    Unzip BIN file, put that on a empty USB.
    Turn off remote.
    Put USB in.
    Turn remote on.
    Leave for 20 sec and it will start with a blue led . . . .
    Leave for 4 min and LED turns green - thats it.

    Hope this helps.
    /ESC