Welcome Inspire Pilots!
Join our free DJI Inspire community today!
Sign up

Update X5 firmware issues

Joined
Jan 14, 2016
Messages
2
Reaction score
0
Age
71
Issues after latest firmware upgrade:
X5 camera firmware
Gimble doesn't center ( have to correct in settings)
also
first test fight after upgrade went ok until I tried to land. The landing gear wouldn't go down. I tried to manually bring the gear down-nothing.
I also tried to have the sensors bring the gear down- nothing ( I hovered a couple inches from the ground). I had to hand catch the drone, my first time doing that ... hopefully my last.
I was able to get the gear to lower after the flight by toggling the H switch 4 times... still don't know if this is going to happen again in flight.
anyone else have these issues?
 
update to these issues. I took the i! out again for a test flight after these incidences . I took off and the landing gear retracted and acted normally. The sensors worked properly and I was able to retract the gear manually with the H toggle. This is a good thing..... however. I flew out over the ocean maybe 1/8 of a mile and started losing video feed. The camera would freeze and the screen pixelate and turn green. I have never had an issue like this until this firmware. I brought it in and changed batteries and tried again. This time was better with only a few screen freezes. This is the worst firmware yet and I have been here from the start .
 
update to these issues. I took the i! out again for a test flight after these incidences . I took off and the landing gear retracted and acted normally. The sensors worked properly and I was able to retract the gear manually with the H toggle. This is a good thing..... however. I flew out over the ocean maybe 1/8 of a mile and started losing video feed. The camera would freeze and the screen pixelate and turn green. I have never had an issue like this until this firmware. I brought it in and changed batteries and tried again. This time was better with only a few screen freezes. This is the worst firmware yet and I have been here from the start .

I have the same camera issues, never had a problem until this latest firmware update. I have tried every thing I can think of, same results. After takeoff, once in awhile without warning, total black screen, In the upper left corner (DISCONNECTED)
It comes and goes. My take up to a minute co reconnect.
I have tried everything other than throwing the camera in the trash can.
 

New Posts

Members online

No members online now.

Forum statistics

Threads
22,290
Messages
210,728
Members
34,485
Latest member
annettekirtont