Welcome to InspirePilots.com

Join the leading DJI Inspire community for free!

Camera feed disappears

Discussion in 'Inspire 1 Help' started by Gary Bateman, May 23, 2015.

  1. Gary Bateman

    Joined:
    May 6, 2015
    Messages:
    60
    Likes Received:
    17
    Yesterday while using my second controller the camera feed went off. Not sure why I was only panning it around filming the cat while the inspire was on the kitchen table. Can't for the life of me get it to come bac on. The gimble works but just no picture. Happens on the master and slave. Any ideas or help would be appreciated.

    Ps it comes on when the gimble calibrates and then goes off after two seconds.
     
  2. sirnikolas

    Joined:
    Feb 24, 2015
    Messages:
    1,460
    Likes Received:
    988
    Location:
    Melbourne Australia
    Power her down.
    Disconnect camera.
    Reconnect camera.
    Power up RC.
    Power her up.
    Job done!
     
  3. Gary Bateman

    Joined:
    May 6, 2015
    Messages:
    60
    Likes Received:
    17
    Tried that but no luck as yet.
     
  4. Gary Bateman

    Joined:
    May 6, 2015
    Messages:
    60
    Likes Received:
    17
    For some reason it's sorted itself out! No idea what it was.
     
  5. sirnikolas

    Joined:
    Feb 24, 2015
    Messages:
    1,460
    Likes Received:
    988
    Location:
    Melbourne Australia
    Ghosts and ghouls in the system.
    Good to hear mate.