Sorry , been away from flying for ages and just turned on the Inspire1 after months. The RC has upgraded fine ,but it says the firmware needs to upgrade.
This is what I have on now, Inspire 1 X3
App 3.0.0
Aircraft 1.8.1.00
RC 1.7.40
Camera (X3) 1.8.1.00
Updating is not new to me and I've successfully done it loads of time over the last couple of years, but this time when I download 1.9.1.30 , format the card, copy the bin file to the card, insert and boot up.......it just boots up as normal and doesn't enter the updating mode. I've re downloaded the bin file loads of times and tried several times without success . Have things changed over the last few months and I'm missing something ??
The red "requires upgrade message" in the app just says refer to the tutorial....which I've done !
This is what I have on now, Inspire 1 X3
App 3.0.0
Aircraft 1.8.1.00
RC 1.7.40
Camera (X3) 1.8.1.00
Updating is not new to me and I've successfully done it loads of time over the last couple of years, but this time when I download 1.9.1.30 , format the card, copy the bin file to the card, insert and boot up.......it just boots up as normal and doesn't enter the updating mode. I've re downloaded the bin file loads of times and tried several times without success . Have things changed over the last few months and I'm missing something ??
The red "requires upgrade message" in the app just says refer to the tutorial....which I've done !