Hello all, looking for feed back on a repair estimate, I have a I2, with the X5S, with a "Camera Sensor Error", (bought Dec 2019) and I have flown it maybe 4 times since purchased - (I've been in a battle with cancer so with the current pandemic I don't get out often)...- note, all functions of the craft work fine, full flight control and full control of the camera movements, FPV camera works fine, just no picture from the X5S...I replaced the vibration absorbing board just to rule that out, yet I still had the same "Camera Sensor" error and no picture. So the camera was sent back under warranty , TWICE - 1st time it came back with the same exact issue, 2nd time it came back and I had a very grainy picture that froze in about 5 seconds, a reboot and other checks of contacts etc and the picture again did the same grainy view for about 5 seconds and froze...another reboot and then nothing, no picture at all, but now there was an added error of "hardware malfunction"... a call to DJI and it was decided to send in the I2 and camera...so today I see the email, DJI is stating they want to replace the following - "Middle Frame Module" (screw mandrel included), Main Controller Module, and Gimbal Vibration Absorbing Board & Cable, so basically just under 1200 dollars...to the many well seasoned vets out there...do these item seem feasible to be bad if the craft functions just fine, landing gear works just fine, flies just fine, FPV camera works fine, full control of all camera movements (pan tilt) and the go 4 app sows the gimbal as "Normal" , just simply no picture from the x5S...$1200 seems is a tough pill to swallow to say the least!!...thank you so much in advance for any input - Sacramento CA.