Hi,
I just bought the Inspire 1 v2, and although I havent used it in air... after the firmware update I:
Cannot caliberate anymore (compass)
Glimbal cannot recieve Main Controller data
Command times out
The light at the back is going insane
Before this he did caliberate but kept one saying there was an error, IMU error
Was so looking forward to this.. Anyone has any ideas?
Oh one more thing, it says:
Check the 8 pin plug that connects the damping plate and the aircraft. Ensure that none of the pins are loose. If the problem persists, contact DJI Support.
I have no idea where the damping plate is, no idea what that is actually. remember I'm dutch and although my english is pretty good, this is the point where i fail.
Thank you
I just bought the Inspire 1 v2, and although I havent used it in air... after the firmware update I:
Cannot caliberate anymore (compass)
Glimbal cannot recieve Main Controller data
Command times out
The light at the back is going insane
Before this he did caliberate but kept one saying there was an error, IMU error
Was so looking forward to this.. Anyone has any ideas?
Oh one more thing, it says:
Check the 8 pin plug that connects the damping plate and the aircraft. Ensure that none of the pins are loose. If the problem persists, contact DJI Support.
I have no idea where the damping plate is, no idea what that is actually. remember I'm dutch and although my english is pretty good, this is the point where i fail.
Thank you