I have just had my Inspire1 returned from DJI following a control unit repair (thats what they told me was wrong anyway!)
It has come back with the following firmware installed:
Aircraft - 1.9.1.30
Controller - 1.7.80
The aircraft will not come out of travel mode.
I have tried to find an answer but nothing seems to work - downgrading the controller firmware, giving the screw a small turn with a screw driver in case it is stuck, mounting the camera with the Inspire supported between two boxes.
When I turn on the Inspire it reports in the app that it is not flight mode with the legs raised. I try putting it in to travel mode and then back to lowering the legs. None of this works.
Is there any one out there that can help?
This is very urgent as we have a job next week so I do not have time to send it back to DJI again!!
It has come back with the following firmware installed:
Aircraft - 1.9.1.30
Controller - 1.7.80
The aircraft will not come out of travel mode.
I have tried to find an answer but nothing seems to work - downgrading the controller firmware, giving the screw a small turn with a screw driver in case it is stuck, mounting the camera with the Inspire supported between two boxes.
When I turn on the Inspire it reports in the app that it is not flight mode with the legs raised. I try putting it in to travel mode and then back to lowering the legs. None of this works.
Is there any one out there that can help?
This is very urgent as we have a job next week so I do not have time to send it back to DJI again!!