M600 Pro: Setting up a Ronin MX with Intelli-G for a GH4 setup.
Also have the X3,X5,X5R, XT gimbal mount and the Z30 mounting plate.
While experimenting, I found when powering up, the X5R or Z3 had no video on iPad but appeared to be functioning. After playing a bit, found setting bandwidth and transmission to include EXT.
Question: Why EXT? If DJI gimbal mount and DJI Gimbal Camera. Why does it not project on the lightbridge video transmission? 2 Leads: 1 to CAN, the other to LB Gimbal port.
How or where is it specified to use EXT instead of LB.
Bandwidth: I noticed the video was pretty poor when M600 got 700-800 ft out in a congested RF neiborhood and EXT set to as low as possible... 30-40%.
What percentage is normally used, and can it be saved to remain
CAN connectors; often indicates to plug into CAN 2 or CAN3, some them different. On the M600, it looks like all CAN ports are the same... like a closed network.
Will I need to do the same with the Ronin MX and SRW60G, use EXt?
Also have the X3,X5,X5R, XT gimbal mount and the Z30 mounting plate.
While experimenting, I found when powering up, the X5R or Z3 had no video on iPad but appeared to be functioning. After playing a bit, found setting bandwidth and transmission to include EXT.
Question: Why EXT? If DJI gimbal mount and DJI Gimbal Camera. Why does it not project on the lightbridge video transmission? 2 Leads: 1 to CAN, the other to LB Gimbal port.
How or where is it specified to use EXT instead of LB.
Bandwidth: I noticed the video was pretty poor when M600 got 700-800 ft out in a congested RF neiborhood and EXT set to as low as possible... 30-40%.
What percentage is normally used, and can it be saved to remain
CAN connectors; often indicates to plug into CAN 2 or CAN3, some them different. On the M600, it looks like all CAN ports are the same... like a closed network.
Will I need to do the same with the Ronin MX and SRW60G, use EXt?