Just upgraded the Firmware to V.1.0.7.90.
Upgraded DJI GO to latest version.
Followed the instructions to upgrade the FC via the APP.
Now, when I switch on the RC I get a Solid Red light.
I go to RC Control Settings, RC Calibration and press Start. Move all the control sticks, but it never gets to finish.
When I switch on the Inspire 1 though the FC light goes green but it wont let me start the FC.
This is all inside so not a temperature issue.
Can anyone help?
Do I need to reload the firmware into the FC using the USB method?
Upgraded DJI GO to latest version.
Followed the instructions to upgrade the FC via the APP.
Now, when I switch on the RC I get a Solid Red light.
I go to RC Control Settings, RC Calibration and press Start. Move all the control sticks, but it never gets to finish.
When I switch on the Inspire 1 though the FC light goes green but it wont let me start the FC.
This is all inside so not a temperature issue.
Can anyone help?
Do I need to reload the firmware into the FC using the USB method?