I recently purchased an Inspire 1, new out of the box and the battery was a dud, tried unplugging the balancing wire inside for as long as 2 hrs with no change in status, no lights, etc.. going around and around with DJI to get a replacement and I think i might be getting one sent finally.
meanwhile I purchased another new tb47 battery and same problem except I unplugged the balancing wire for a little while again and no change so I tried another alternative to see if I could hook direct to the pos and neg right on top under the white cover to try to "jump start" the battery.. I now get a red light on the button and the furthest led from the button flashes then shuts off. I hooked my multimeter to the battery and checked the voltage which is registering mid 5.35 range but even with it plugged in regularly to the charger I see the voltage is still dropping. Any suggestions because I am getting very frustrated with DJI and their products, I have had my inspire almost 2 weeks now and still have not been able to even turn it on
meanwhile I purchased another new tb47 battery and same problem except I unplugged the balancing wire for a little while again and no change so I tried another alternative to see if I could hook direct to the pos and neg right on top under the white cover to try to "jump start" the battery.. I now get a red light on the button and the furthest led from the button flashes then shuts off. I hooked my multimeter to the battery and checked the voltage which is registering mid 5.35 range but even with it plugged in regularly to the charger I see the voltage is still dropping. Any suggestions because I am getting very frustrated with DJI and their products, I have had my inspire almost 2 weeks now and still have not been able to even turn it on