I bought a used Inspire 1 V2, which the previous owner said had just been repaired by DJI, including replacement of the main carbon fiber arms between the body and the landing gear/motors. I also bought an Bestem InsPak X5 case, which will hold the Inspire 1 in landing mode with an X5 camera. However my Inspire 1 (with the X5 gear extensions) will not fit into the case, the landing gear pads are too close together by about an inch or so. Bestem claims they have never heard of an Inspire 1 not fitting into this case, so I was wondering if somehow DJI didn't mount the landing gear/motor mounts at the correct angle when they repaired it. I have not flown it yet.
Could someone measure the width of their Inspire 1 landing gear pads in landing mode, so I can tell if mine is correct? I turned my Inspire upside down, and the landing gear pads at the widest part measure 14 7/16" at the front and 14 3/16" at the rear. Crazy, that means the motors are angled differently at the front and the rear. I probably should send it back to DJI to have them look at it.
Thanks
Could someone measure the width of their Inspire 1 landing gear pads in landing mode, so I can tell if mine is correct? I turned my Inspire upside down, and the landing gear pads at the widest part measure 14 7/16" at the front and 14 3/16" at the rear. Crazy, that means the motors are angled differently at the front and the rear. I probably should send it back to DJI to have them look at it.
Thanks