Hi all,
Got a problem with the worm screw not engaging with the motor. If I manually push the screw toward the motor housing whilst turning the screw (relative to lowering or raising) it will engage, however in normal operation it skips out of gearing and the motor runs on, also leaving the worm screw to move laterally.
Any ideas why this would be occurring?
Got a problem with the worm screw not engaging with the motor. If I manually push the screw toward the motor housing whilst turning the screw (relative to lowering or raising) it will engage, however in normal operation it skips out of gearing and the motor runs on, also leaving the worm screw to move laterally.
Any ideas why this would be occurring?