- Joined
- Feb 3, 2017
- Messages
- 203
- Reaction score
- 126
- Age
- 72
Received a new Inspire 2 last evening, upgraded firmware, tested the camera and gimbal inside without flying the drone. Removed the X4S and replaced it in its case.
This morning, set up for maiden voyage, reconnected the X4S, and proceeded outside.
Immediately noticed the video image was 90 degrees off and corresponded to the gimbal position, which did not move or auto calibrate.
Reinstalled latest firmware, performed IMU calibration successfully and then attempted gimbal calibration to no avail.
Requested a new X4S, but do not know if the problem is in the camera or the drone. Anyone experience anything like this?
Thanks in advance.
This morning, set up for maiden voyage, reconnected the X4S, and proceeded outside.
Immediately noticed the video image was 90 degrees off and corresponded to the gimbal position, which did not move or auto calibrate.
Reinstalled latest firmware, performed IMU calibration successfully and then attempted gimbal calibration to no avail.
Requested a new X4S, but do not know if the problem is in the camera or the drone. Anyone experience anything like this?
Thanks in advance.