Hi!
My inspire 1 v2 x5 raw gimble starts OK for exsactly 3 seconds and goes lame. For the last few weeks sometimes on start up the gimble got stuck, so I just gave it a push and it would be fine.
I've tested the X5R on my osmo and it's fine, so it's not the gimble, I've changed the contact board and the two wires behind the nose, so it's not them. I've calibrated the gimble, and imu also firmware update. Still the same. I put my x3 on the drone and it does the same thing. There is no transmission single ethier.
Anyone had these issues?
Thinking of putting a NCORE pet 1 on and see if it works.
Can anybody help????
Thanks,
Paul.
My inspire 1 v2 x5 raw gimble starts OK for exsactly 3 seconds and goes lame. For the last few weeks sometimes on start up the gimble got stuck, so I just gave it a push and it would be fine.
I've tested the X5R on my osmo and it's fine, so it's not the gimble, I've changed the contact board and the two wires behind the nose, so it's not them. I've calibrated the gimble, and imu also firmware update. Still the same. I put my x3 on the drone and it does the same thing. There is no transmission single ethier.
Anyone had these issues?
Thinking of putting a NCORE pet 1 on and see if it works.
Can anybody help????
Thanks,
Paul.