Recent content by curso88

B model is designed to set a master. GL658C Model transmit power 0,740 W GL658C Model transmit power 0,015 W

I have the genuine Xexun TK102-2 GPS GSM tracker (not Chinese copy) and works very fine. 1-3 meter accurate

I have one of my TB 48 batteries with this problem too. The battery is genuine but not serial. I use IOs

Hello I same issue sometimes. I have observed in my Inspire 1 V2 model T601 altitude variations in hovering mode. The aircraft was positioned at an altitude of about 5 meters when I was doing battery discharge. After about 10 minutes the aircraft began to climb slowly about 4 meters and...

Hello I same issue sometimes. I have observed in my Inspire 1 V2 model T601 altitude variations in hovering mode. The aircraft was positioned at an altitude of about 5 meters when I was doing battery discharge. After about 10 minutes the aircraft began to climb slowly about 4 meters and...

I have observed in my Inspire 1 V2 model T601 altitude variations in hovering mode. The aircraft was positioned at an altitude of about 5 meters when I was doing battery discharge. After about 10 minutes the aircraft began to climb slowly about 4 meters and stopped ascending. In this moment, The...

I have a contact in DJI working in Shenzhen (China). I have pictures of the modules and the MAC. When you have a moment I will publish. He asked this at work, and engineers told him that a normal user would not care this. My name is curso88 and I the admin of INSPILOTS SPAIN in FB Best Reagards

Hi This is my post in spanish about the hardware diferences in the Model T600 and the Model T601: The model V2.0 but labeled as T600 not have the same mother board and transmitter modules, OFDM, etc. that the real V2.0 T601...

Bug report on the App DJI GO & Go Geo Beta using IOs 9.3.1 FIXED When update the IOs 9.3.2 firmware 1- Update your IOs 9.3.1 to 9.3.2 2- Uninstall and reinstall the DJI GO app Best Regards Alejandro Gomez Inspilots Spain Admin DJI Betatester

This bug has detected in the APP DJI GO & GO GEO Beta using the Inspire 1 V2, the Phantom 3 Profesional and the DJI OSMO using the App in the iPad Air 2, iPad 4 and two iPhone 6 Plus with IOS 9.3.1 and the current version from App Store DJI GO v2.8.1 and the current release of DJI GO GEO Beta...

VPS bug

I have managed to reproduce the problem in my Inspire 1 V2.0 To reproduce this issue or bug first connect your RC and app and your Inspire 1. Exit from travel mode, turn off the aircraft to place your camera. Turn ON the aircraft and check it that all is correct. If you not have GPS signal the...

Hello Some times, when turn on the aircraft, in good light conditions and in a pattern surface, the optical system of the VPS not works, the app sow ATTI mode but the sonar works well. To solve this problem I restart the aircraft, and the problem disappears, and the P-Opti works well. I do not...

The p-opti system works sometimes bad in the 1.6 and 1.7 firmware

Hello I purchased the Inspire 1 and I updated the craft. After the update I had the same issue. The DJI Pilot has sowed System Error momentarily for a few seconds. you have had any problems after this with your Inspire? All correct? Thanks in advance