- Joined
- Jun 12, 2014
- Messages
- 49
- Reaction score
- 28
- @Jeff. Can you please tell in which condition you make your mesurement : 1 You take the drone in landing mode and you put it on a table or 2. you put it on a table in transport mode and active the landing mode and let the aircraft come alone in landing mode.
I place the I2 on a table in transport mode, I then convert it to landing mode and take the measurement. It’s pretty consistent every time.
As to your question about glue and screw tightening, I would never use glue unless it was designed to be there. As to screws, I use blue loktite on the threads and only tighten down until any unnecessary motion of the restrained component is removed.