Working on a job where I need to create a time lapse of a contraction project. I was planning to use Litchi's Waypoints and Orbit, however I have run a few test flights and the gimbal movement is all over the place (jerking up, down, left and right without focusing on the point of interest). Only solution I can find is to manually control the gimbal which isn't ideal given the positioning will be slightly different between each shoot. Has anyone else seen this issue? Thoughts on how to resolve?
In the waypoints, I have created a single point of interest at the center of the construction site. I have multiple waypoints around the front, back and side. I have each waypoint set to focus on POI 1, Gimbal Pitch Mode is set to Focus POI and in the overall mission settings the default gimbal pitch mode is set to Focus POI. Similar thing is happening when doing the orbit.
In the waypoints, I have created a single point of interest at the center of the construction site. I have multiple waypoints around the front, back and side. I have each waypoint set to focus on POI 1, Gimbal Pitch Mode is set to Focus POI and in the overall mission settings the default gimbal pitch mode is set to Focus POI. Similar thing is happening when doing the orbit.