DJI flysafe Geo update and unlocking areas

[Firefly_AI]

Apologies if this has been posted before.

Flying in UK. On latest FW (Inspire 1 Firmware v1.8.1.00). Downloaded the geo beta app on android and unlocked a restricted area (Coventry, Ryton). Area shows in the app as a valid unlock but when I go to arm the inspire, it says I am in a no-fly zone and won't arm.

Do I need to download the beta aircraft FW also (Inspire 1 Beta Firmware V01.09.01.02)? I take it this would be across all components (batteries, TX etc..)

I have a job on Wednesday and need to get this sorted!

Any help or experiences would be very much appreciated.

(we have all permissions in place for this; ATC, police, landowner and Air Ambulance)

 

[Canuck32]

RC doesn't need update, just the inspire needs update to get FW. never hurts though to check other batts in case they are on old FW.

 

[Firefly_AI]

RC doesn't need update, just the inspire needs update to get FW. never hurts though to check other batts in case they are on old FW.

Thanks. Have two jobs tomorrow, so think it wise to get these done and dusted and then worry about the update. I'd rather get a test flight in following an update than just go straight into it. I also can't risk locking out anything for tomorrow...