Hello pilots,
Today I was flying as usual when I lost transmission signal to my camera. I brought it in immediately for inspection and the x3 was hanging down from the inspire by only 1 of the rubber pieces and two wires.
So, two questions:
1. Should there be a screw here?
View without X3 mount, looking at the bright sliver hole in the middle.:
Where the screw would be if the x3 mount was on:
I believe this could have caused my camera x3 to almost fall off by way of the rubber pieces working their way out during flight. My inspire has a lot of flight hours and has been sent in one time for warranty repair for a loose arm on the left that also happened mid flight.
2. If I try reconnecting the rubber pieces to the mount, plug the wires back in, and turn on the drone, the x3 operates fine except there is still no image transmission signal. I am able to operate and move the X3 camera from the controller, but there is no image signal.
Has anyone had their camera disconnected like this before and had trouble fixing the image transmission?
Would love to have this bird back in the air without having to send it in again.
Regards,
Today I was flying as usual when I lost transmission signal to my camera. I brought it in immediately for inspection and the x3 was hanging down from the inspire by only 1 of the rubber pieces and two wires.
So, two questions:
1. Should there be a screw here?
View without X3 mount, looking at the bright sliver hole in the middle.:
Where the screw would be if the x3 mount was on:
I believe this could have caused my camera x3 to almost fall off by way of the rubber pieces working their way out during flight. My inspire has a lot of flight hours and has been sent in one time for warranty repair for a loose arm on the left that also happened mid flight.
2. If I try reconnecting the rubber pieces to the mount, plug the wires back in, and turn on the drone, the x3 operates fine except there is still no image transmission signal. I am able to operate and move the X3 camera from the controller, but there is no image signal.
Has anyone had their camera disconnected like this before and had trouble fixing the image transmission?
Would love to have this bird back in the air without having to send it in again.
Regards,